hostapd: Remove unused passive scan functionality

[wpasupplicant] / hostapd / hostapd.conf

diff --git a/hostapd/hostapd.conf b/hostapd/hostapd.conf
index 117e1d5..796c0d6 100644 (file)
--- a/hostapd/hostapd.conf
+++ b/hostapd/hostapd.conf
@@ -825,27 +825,11 @@ own_ip_addr=127.0.0.1
 # 1 = push PMK-R1 to all configured R1KHs whenever a new PMK-R0 is derived
 #pmk_r1_push=1
 
-##### Passive scanning ########################################################
-# Scan different channels every N seconds. 0 = disable passive scanning.
-#passive_scan_interval=60
-
-# Listen N usecs on each channel when doing passive scanning.
-# This value plus the time needed for changing channels should be less than
-# 32 milliseconds (i.e. 32000 usec) to avoid interruptions to normal
-# operations. Time needed for channel changing varies based on the used wlan
-# hardware.
-# default: disabled (0)
-#passive_scan_listen=10000
-
-# Passive scanning mode:
-# 0 = scan all supported modes (802.11a/b/g/Turbo) (default)
-# 1 = scan only the mode that is currently used for normal operations
-#passive_scan_mode=1
-
-# Maximum number of entries kept in AP table (either for passive scanning or
-# for detecting Overlapping Legacy BSS Condition). The oldest entry will be
+##### Neighbor table ##########################################################
+# Maximum number of entries kept in AP table (either for neigbor table or for
+# detecting Overlapping Legacy BSS Condition). The oldest entry will be
 # removed when adding a new entry that would make the list grow over this
-# limit. Note! Wi-Fi certification for IEEE 802.11g requires that OLBC is
+# limit. Note! WFA certification for IEEE 802.11g requires that OLBC is
 # enabled, so this field should not be set to 0 when using IEEE 802.11g.
 # default: 255
 #ap_table_max_size=255