<varlistentry>
<term>
<command>
+ <option>format_time</option>
+ </command>
+ <option>seconds format</option>
+ </term>
+ <listitem>Format time given in seconds. This var only works when
+ the times_in_seconds configuration setting is on. Format is a string
+ that should start and end with a "-char. The "-chars are not
+ part of the output, \w,\d,\h,\m,\s,\(,\) and \\ are replaced by
+ weeks,days,hours,minutes,seconds,(,) and \. If you leave out a unit,
+ it's value will be expressed in the highest unite lower then the
+ one left out. Text between ()-chars will not be visible if a
+ replaced unit in this text is 0. If seconds is a decimal number
+ then you can see the numbers behind the point by using \S
+ followed by a number that specifies the amount of
+ digits behind the point that you want to see (maximum 9).
+ You can also place a 'x' behind \S so you have all digits behind
+ the point and no trailing zero's. (also maximum 9)
+ <para /></listitem>
+ </varlistentry>
+ <varlistentry>
+ <term>
+ <command>
<option>forwarded_mails</option>
</command>
<option>(maildir)</option>
<varlistentry>
<term>
<command>
+ <option>pid_read</option>
+ </command>
+ <option>pid</option>
+ </term>
+ <listitem>Total number of bytes read by the process
+ <para /></listitem>
+ </varlistentry>
+ <varlistentry>
+ <term>
+ <command>
<option>pid_state</option>
</command>
<option>pid</option>
<varlistentry>
<term>
<command>
+ <option>pid_write</option>
+ </command>
+ <option>pid</option>
+ </term>
+ <listitem>Total number of bytes written by the process
+ <para /></listitem>
+ </varlistentry>
+ <varlistentry>
+ <term>
+ <command>
<option>platform</option>
</command>
<option>(dev) type n (factor offset)</option>
<option>tcp_portmon</option>
</command>
<option>port_begin port_end item (index)</option>
- <emphasis>(ip4 only at present)</emphasis>
</term>
<listitem>
- <para>TCP port monitor for specified local ports. Port
- numbers must be in the range 1 to 65535. Valid items
- are:</para>
+ <para>TCP port (both IPv6 and IPv4) monitor for
+ specified local ports. Port numbers must be in
+ the range 1 to 65535. Valid items are:</para>
<simplelist>
<member>
<command>count</command>